PanelMate® Pro Driver Socket ELCO 3/16" Driver
Must-have Tool for Installing all ELCO Male PanelMates
- If you’re installing PanelMates, don’t forget the driver!
- 1/4" hex drive shaft with ball groove for both drills and impact drivers
- An essential tool for correctly installing your hurricane hardware
- The 3/16" drive socket is for PanelMate® Pro series and TVAS brick anchors
You won't find this tool at the home centers
Top of thge line
Posted by Dave Shutt on 12 18 2019
Works Great. Much better than a socket and doesn't wear out.
Allows a Speedy Installation
Posted by John B. Corpus Christi, TX on 08 28 2018
Great product for installing PanelMate pro anchors. We used these to install overhead male anchors in a house built of hardy plank. These allow for a fast installation through concrete plank and plywood in to the framing 2x4s. Bought a couple but one did the job.
A necessary tool
Posted by pjn on 08 16 2018
Without this tool, installation would not have gone so smoothly. Designed for the job it was supposed to do. I bought 2 in the event one would break or go missing.
This bit makes it easy
Posted by Unknown on 06 23 2018
Don't even attempt to install these screws without this tool. It makes it SO easy. Did 2 homes in less than 3 hours (including measuring). Used to be an all weekend job.
Posted by Michelle Ruiz on 06 05 2018
I have a island home on the water and needed a reliable company that could provide me with quality products. I need stainless steel nothing else. After multiple searches from the traditional stores I found Windstorm. 1. they knew what I needed
2. they promised and delivered
3. they followed up.
BEST SERVICE BEST PRODUCTS BEST COMPANY
They have my business for life.
Driver absolutely necessary for large installations
Posted by Unknown on 08 15 2014
This driver works excellently to install PanelMate Pro Anchors, especially if you are doing an installation requiring many fasteners. I recommend getting two, just in case you misplace one.